I want to know if there is a simple solution to this - such as resetting the GEM (the inside electric module) in front of the passenger chair. Also if there is no possibility to reset it or something similar i would like to know where i could get some decent prices for this?

A word of advice, before you start this have the radio codes ready with you or you have to go to Ford dealership to get them. There is no other way. They com
Posted August 30, 2016. The software of the Focus MK2/MK2.5 GEM module can not be updated. There are several versions of the GEM module installed during production. Each part number supports different options. The GEM module should only be replaced by another one that supports the same (or more) options otherwise some functions may not work. As
The GEM module is mounted on top of the interior fuse box with 3 screws. You will need to remove the fuse box and GEM together as an assembly to inspect it. Remove the two large bulkhead connectors on the back of the fusebox, (they are bolted in place with a long 10mm headed bolt), remove the two nuts and two bolts securing the fusebox, slide
This is direct from the service manual: NOTE: The GEM must be reconfigured upon replacement. Refer to the NGS Tester help screen on the Ford Service Function (FSF) card to program tire size and axle ratio. The GEM/CTM controls the following functions: Wipers/washers. Warning chimes.
20A Module of electrical equipment of the left rear door: 119: 15A Luggage compartment socket: 119: 25A Socket in luggage compartment (with trailer module) 120: 20A Module of electrical equipment of the right rear door: 121: 20A Heated front seats: 122: 10A Airbags: 123: 7.5A Heated mirrors: 124: 7.5A Side light left side: 125: 7.5A Side light
The Focus MK2/MK2.5 radio uses the CAN-bus signal for AVC. The analog AVC pin is only used on a Focus MK2/MK2.5 without ABS and some other Ford models which do not have the CAN-bus speed signal. Some types of GEM module/fuse box have the possibility to convert the CAN-bus speed signal to an analog speed signal.
Topic Guide Fitting Cruise Control Focus Mk2 & Mk2.5 And Ford C-Max page 30 member TitaniumPenguin wrote the whole procedure how PCM module could be programmed. Topic Guide For Focus Mk2/mk2.5 C-Max/kuga ~Elm 327 Cable And Ff2 Program page 59 member JW1982 wrote the whole procedure how PCM module could be programmed.
Ford Model: Fiesta. Ford Year: 2006. UK/Ireland Location: Other/NonUK. Posted September 1, 2013. Just change the GEM and program the fob key with the GEM and you are good to go. Turn the key from pos 2 to pos 1 for 4 times. The GEM beeps and then press any button on the fob, it should beep back and you are done :) Quote. Restraints control module F61 7.5 Passive anti-theft transceiver module, Instrument cluster F62 7.5 Audio Unit F63 20 Generic Electronic Module (GEM) legend (late production). Fuse Amps Circuits protected F30 10 Main light switch F31 20 Radio F32 15 Generic Electronic Module (GEM) F33 20 Roof opening panel F34 20 Horn F35 7.5 Instrument Relays location: Relay: Engine compartment relay module #1: ABS pump: R. trailer turn: Rear wiper down: Rear wiper up: L. trailer turn: ABS main: Engine compartment relay module #2: Blower motor: Hi-speed blower: Fog lamp: Front washer pump: Engine compartment relay module #3: Automatic ride control: Instrument panel relay module #4: Dimmer
The BCM is the back section of the passenger compartment fusebox. Examples of what it looks like: Name: Wilco. Ford Model: Kuga Vignale. Ford Year: 2018. UK/Ireland Location: Other/NonUK. Posted June 11, 2022. In fact the Focus MK2/MK2.5 does have a GEM (General Electronics Module) and not a BCM (Body Control Module).
A 13 plate will be a Focus MK3. This type of module is not compatible with your MK2. The Focus MK2 and very early MK2.5 did have the old mono Bluetooth/Voicecontrol system. This was basically the 1st generation Bluetooth/Voicecontrol system. This system did only support bluetooth and Voicecontrol. The software of this system can not be updated.
How to test GEM module in Ford Focus MK2 C-Max (car diagnostics) 4.9 (182) Where is the Paint Code Colour Code Location: Ford Focus Mk C-Max 2004 2011. 4Q7ci.
  • g1klq0faii.pages.dev/139
  • g1klq0faii.pages.dev/89
  • g1klq0faii.pages.dev/160
  • g1klq0faii.pages.dev/278
  • g1klq0faii.pages.dev/243
  • g1klq0faii.pages.dev/420
  • g1klq0faii.pages.dev/191
  • g1klq0faii.pages.dev/569

    • ford focus mk2 gem module location